[Paper Width Adjustment]
Overview
Adjust the punch hole position of FoldingUnit FD-503. Perform this function when the punch holes are very misaligned.
Tips
- If a numeric value is entered in [Offset for All Size], it is applied to all the paper sizes. If a numeric value is entered for a specific paper size, the setting value becomes the sum of the entered value of the specific paper size and the entered value of [Offset for All Size].
Specifications
Category | Adjustment / Maintenance | ||
Location | Machine | Touch Panel | |
Printer driver | - | ||
Application | - | ||
Required options | FoldingUnit FD-503 | ||
Required items | - | ||
Setting items | [Offset for All Size] | Sets the punch position common to all the paper sizes. | |
Paper size selection key | Selects the paper size to adjust. | ||
[+] / [,] | Switches the paper size page. | ||
Keypad | Used to enter numeric values. | ||
[Clear] | Returns the entered numeric value to "0". | ||
[Set] | Sets the numeric value entered using the keypad to the selected setting item. | ||
Remarks | - | ||
Reference | - | ||
Screen access | Touch panel - [MACHINE] - [Adjustment] - [Finisher Adjustment] - [Multi Folder Adjustment] - [Multi Folder(Punch) Adj.] - [Paper Width Adjustment] | ||
Control panel - Utility/Counter - [Administrator Setting] - [System Setting] - [Expert Adjustment] - [Finisher Adjustment] - [Multi Folder Adjustment] - [Multi Folder(Punch) Adj.] - [Paper Width Adjustment] | |||
Procedure
1
Press the selection key of the paper size to adjust.
2
Select [Print Mode].
3
Load the paper of the size selected in step 1 into any paper tray, and select that paper tray.
4
Set the number of copies to 10, and press Start on the Control panel.
A sample is output.
5
Check the diameter of holes penetrating through piled output sets.
Number of punch holes | Standard value |
|---|---|
2 holes / 4 holes | 5.0 mm or more in diameter |
3 holes | 6.5 mm or more in diameter |
6
If any adjustments are required, press [Exit PrintMode] to return to the setting screen.
7
Use the on-screen keypad to enter the numeric value.
Use [+]/[-] to select the plus or minus of the numeric value. To change [Current Data], press [Set].
[Adj. Range:-20~+20 1step = 0.1mm]
Adjust the setting value by referencing the figure.
If the setting value is too great, the center of punch holes may be misaligned. If the setting value is too small, the punch hole positions may become uneven.
8
Repeat step 2 to step 7 until the desired result is obtained.
in the upper-right of a page, it turns into 
and is registered as a bookmark.